Horizontal Loop

Ground Source Surface Collector

During the summer, solar heat is stored in the soil. This is either directly absorbed as insulation or as heat from rain and the air from the near-surface layer of the soil. Using this energy for heating is a cost effective method. The highest yield can be obtained from soil with high water content. The heat is extracted from the soil by means of buried plastic tubing. An environmentally-friendly, non-freezing emulsion of water and glycol circulates in the tubing. The soil above the earth collector may not be sealed off under any circumstances, i.e. by buildings, asphalt or concrete.

Earth collectors do not require a permit. Installation depth is approx. 20 cm below the local frost line.

Marlborough Heating can design, supply and install a ground source heat pump system appropriate to your requirements, please get in touch via the contact us page to discuss your project.

Ground Source Surface Collector